Transom after I cleaned it up, and before resurfacing. Note the Gel-coat is burned through and missing in many areas.
During resurfacing using West Marine surfacing putty.
Pintle and Gudgeon and weathered mounting blocks.
After some work with a wire wheel and belt sander, then some red mahogany stain.
Outboard motor mount rails (top) before sanding (bottom) after sanding.
Mount rails after sanding and staining.
Rudder had been repaired and encased in either epoxy or gel-coat.
After sanding off previous repair. I will be using west systems epoxy to repair and clear coat this beautiful slab of mahogany.
Carefully picking out the filler that was used in the previous repair.
No comments:
Post a Comment